(image for) Agafix Spares - Discount Aga Range Cooker and Rayburn Range Cooker Spares on the web.

Roast Oven Doorback Renovation Kit for Aga Range Cookers

£65.46

Please Choose:

Aga Range Cooker Model







Sometimes after years of use the screws holding the Aga Range Cooker roast door back on work loose and no amount of tightening will help.

On taking the door back off it becomes obvious that the blind thread into the door has worn, or the actual screw has broken off. These are 1/4 inch whitworth threaded and screw into a blind hole about 1/4 inch deep in the cast iron.

You cannot re-tap as there isn't enough cast iron to take a wider screw. You can't weld a nut in place as it would damage the enamel. Another door would maybe not match the colour as enamelling isn't an exact science and the hinge pins would need bending to get a good seal as your door is worn and could be up to 70 years old!

We offer a solution in the form of a Door Renovation Kit and it contains all you MIGHT need.Please note that this is a skilled job and we cannot guarantee you will get it right. But at least you will have all the parts to do the job. If outside your skills we suggest you take to a competent engineer.

Our kit consists of the following:
  • 6 x 1/4 inch Whitworth door screws - that's 4 you need, plus 2 extra if you need to make studs
  • 4 x 1/4 inch barrel nuts
  • 1 pack of mouldable metal to make a new base for the mounting nut/screw, with instructions
  • 1 Roast door insulation pad
  • 1 Roast door back
  • 2 metres of 8 and 10mm ceramic rope to make up a new door seal
  • 1 tube of Everflex high heat silicone insulation

Please specify which version door back you require from the list below. (See our Which Aga Range Cooker do I have section on left side of start page if not sure!)

We also offer a set of taps to remake the thread as an extra - see here.

Your IP Address is: 54.196.248.93
Copyright © 2024 Agafix Spares
(image for) Ebooks 2