For re-tapping those 3 bolt holes in bottom oven and leg mounts in base plate. These tap sets consist of a starter, middle and blind tap.
Invaluable on Standard Aga range cooker for most small bolt/ screw holes. These tap sets consist of a starter, middle and blind tap.
Re-tap the brass screw headed bolt holes in cast and chrome domes. These tap sets consist of a starter, middle and blind tap.
Especially useful for deluxe under oven heat transfer plate adjustment lugs. These tap sets consist of a starter, middle and blind tap.
As with our 1/4 inch set this 5/16th inch set is used a lot on both Standard and Deluxe models. These tap sets consist of a starter, middle and blind tap.
Update 01/11/2022: We have just sold our last stock and are unable to replenish. If you need a catch please contact us as we may be able to supply used. Brass...
£144.00... more info
Update 01/11/2022: We have just sold our last stock of new ball catches and are unable to replenish. When available we will be listing used ones here. Please...
£60.00... more info
2 required each Aga range cooker, fits all models inc balanced flue.
Big bolts with nuts and washers to hold outer barrel to oven manifold
Mount through the roof of the lower oven (all models) to adjust height of top oven. Recessed hex style for easy adjustment
Ideal if full of enamel!
Make sure your ash pit door shuts properly!
Some Deluxe Post 74 hinge blocks had a SINGLE grub screw fitted at the rear of the block. We sell these in pairs. They are 1/4 Whitworth thread with a...
These grub screws fit the Pre 74 Aga range cooker hinge block ONLY (see here ) at each end (via the front drilled holes) and simply screw in to the grooves...
Holds the tie rods tight, pulling top down on Standard models ONLY, 4 or 2 oven versions, any fuel- 4 on 2 oven cookers, 8 on 4 oven versions. Please add the...